725-B43-9 Acrylic finish paint

Product Description

-A quick drying single pack acrylic finish

-VOC less than 500g/L

Intended Uses

-A cosmetic finish

-For use in all above water areas

-Suitable for application at low temperature

-For use at Newbuilding, Maintenance and Repair or On Board Maintenance

Product Information

Volume Solids

40%±3%

Finish/Sheen

gloss

Typical Film Thickness

40microns dry (100microns wet)

Theoretical Coverage

10m2/L at typical film thickness

Mix ratio

One pack

Method of Application

Airless Spray

Recommended

Tip size range

0.38-0.53mm

Output pressure

≥17MPa

Air Spray

Tip size range

2.0-3.0mm

Output pressure

≥0.4MPa

Brush/Roller

For small area only

Thinner

Not recommended. Use only in exceptional circumstances (volume 5%)

Cleaner

BX-901

Induction Period

Not applicable

Drying Information

-5°C

5°C

25°C

35°C

Touch Dry

2h

1h

30min

15min

Hard Dry

24h

20h

12h

8h

Pot Life

Not applicable

Overcoating Data          Substrate Temperature

Overcoated by

725-B43-9

-5°C

5°C

25°C

35°C

Min Max

Min Max

Min Max

Min Max

24h -

16h -

8h -

4h -

Storage

Store in cool and dry conditions. Well ventilate. Keep away from hot and fire. Shelf Life: 12 months minimum at 25°C. Subject to re-inspection thereafter

Pack Size

21.6kg/18L in 20 L container

Flash Point

Greater than 31°C

Systems and

Compatibility

Consult your Sunrui Representative for the systems best suited for the surfaces to be protected.

Surface Preparation

High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. All surfaces to be coated should be clean, dry and free from contamination.

Newbuilding/Major Refurbishment

725-B43-9 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination. 725-B43-9 must be applied within the coating interval specified (consult the relevant product data sheet). Areas of breakdown, damage etc. should be prepared to the specified standard (eg. St3) and primed prior to the application of 725-B43-9.

Repair/On Board Maintenance

725-B43-9 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination.725-B43-9 must be applied within the coating interval specified (consult the relevant product data sheet). Areas of breakdown, damage etc. should be prepared to the specified standard (eg. St3) and primed prior to the application of 725-B43-9.

725-B43-9 may be applied directly over aged 725-B43-9 following thorough fresh water washing and degreasing provided the coating to be overcoated is in an intact and tightly adherent condition. Loose or flaking coatings should be removed back to a firm edge and an appropriate primer should be used to repair the area before application of the full coat.